Loading... Please wait...


Our Newsletter

100 Litre C2 Fibreglass Pressure Tank - 10 Bar 1"

  • Three sizes shown for illustration purposes
  • Image 2
Calculated at checkout
Shipping Zones

Product Description

It is recommended to use a pressure tank especially when a pump is connected to a toilet cistern. After a toilet is flushed it fills slowly and can cause a pump to cycle (switch on and off) until the cistern is full. Installation of a pressure tank will assist in eliminating this cycling.

Pressure Tanks are recommended to be installed in-line with pumps as they are:

  • An energy saving device
  • Eliminates the pump starting each time a tap is turned on
  • Extends the life of your pump
  • Reduces noise
  • Protects against heat expansion
  • Stops water wastage from hot water heaters
  • Stores energy

Draw Off - 36 litres
This means that when a tap is turned, the water in the pressure cell is used first prior to the pump being turned on. This model will use 36 litres of water stored in the pressure cell prior to the turning on of the pump. Once this water is used, the pump will start. When the tap is turned off, the pump will continue to run to fill the pressure cell tank before the pump turns off.


  • Light weight non-corroding scratch resistant construction 
  • Precision injection moulded copolymer polypropylene domes
  • Reinforced with durable continuous strand fibreglass
  • Sealed with epoxy resin. Rugged injection moulded ABS base
  • Patented CAD-2 controlled action diaphragm, 100% portable quality butyl
  • Internal clench ring becomes even more positive at higher pressures
  • Double diaphragm reduces condensation due to ‘air buffer’ design
  • Maximum temperature up to 60 degrees C
  • Standard maximum pressure 150 psi / 10 Bar
  • 5 Year Tank Replacement Guarantee


For PRESSURE SWITCH CONTROLLED PUMPS with traditional pressure differential of up to 140kPa (20psi), pre-charge to be 20kPa (3psi) below cut in pressure. For PUMPS CONTROLLED BY EITHER PRESSURE SWITCHES with differential over 140kPa (20psi), ELECTRONIC CONTROLLERS or VFD (variable speed drive) the prechange pressure should be set at 65% of the maximum system pressure. ONCE the pre-charge is set, no regular air charge checks are required.

Other Details

100 Litres
Draw Off:
36 Litres

Find Similar Products by Category

Write your own product review

Product Reviews

This product hasn't received any reviews yet. Be the first to review this product!